We are spinning up a VM test environment an planning on using SCVMM to build bare host as hyper-v hosts. The operating system being used is Windows Server 2012 R2. Our physical host have 4 network jacks (1 dual jack card an the 2 jacks on the motherboard) which we would like setup in the following configuration....
Eth0 used for management only
Microsoft Network Adaptor Multiplexor Driver (Virt NIC) used for VM Network.
Eth1, 2, & 3 Bound to Multiplexor
I am given to understand that SCVMM has a way to configure each hyper-v host by using network profiles, but I am having a difficult time understanding the dependencies an requirements to set that up if that is indeed the correct route.
Any assistance would be welcomed.